Ring and spade tongur terminals
Marking accessories

UMCT3129

136.00 + VAT

PCS PER PACK1

In stock

In stock

Tool designed for use by the installer. The matrices move parallel to each other and generate a force of 10,000 N. The entire tool is covered with a plastic body that makes it ergonomic and comfortable to use
open the pliers as wide as possible
slowly bring the two levers of the pliers together, until the locking/release mechanism makes three clicks
observe the anchorage stud on the matrix
insert the matrix, moving the anchorage stud towards the internal part of the pliers chamber
make sure that the plastic tooth has locked the matrix in place or that it has risen
press the two levers of the pliers, closing them as tightly as possible
release the handles; the pliers should open automatically and completely
if, when the pliers are closing, you realise that the crimping is not successful or the crimp tool is blocked for any reason, it can be released by pressing and releasing the handles alternatively a few times and simultaneously using your thumb to press the release lever on the internal part of the handle

Additional information

Code
Description
HS code
Section
Pieces per box

NOTES

For further information see PDF catalog

DU070R
Red coloured partition, with direct fixing on the terminal block,...
CABUR AF201 END SECTION PT SERIES
TL101GR
End plate, colour grey, suitable for TLE.2/GR, TLS.2/GR
SF993
3 A diode cartridge
SF992
1 A diode cartridge
Cabur CONTC01 FLYING SCREW TERMINAL BLOCKS CONTC SERIES FOR JUNCTION BOXES
CONTC04N
screw terminal for junction boxes, 4 mm²
Cabur CONTC01 FLYING SCREW TERMINAL BLOCKS CONTC SERIES FOR JUNCTION BOXES
CONTC02N
Screw terminal for junction boxes, 2.5 mm²
Cabur CONTC01 FLYING SCREW TERMINAL BLOCKS CONTC SERIES FOR JUNCTION BOXES
CONTC01N
screw terminal for junction boxes, 1.5 mm²
SB320GR
screw terminal block for test and measurement circuits, 4 mm²,...
SB310GR
screw terminal block for test and measurement circuits, 4 mm²,...
PHD02
Plug-in internal connection, yellow, suitable for HMD.2

IN THE SAME CATEGORY

Cabur NU0835S SMARTPRINT+, CABURJET TESSERE PER ALTRI MORSETTI
Solutions for industrial marking system

Cabur presents the new NU series tags for 1.5 mm2 terminals

To complete the range of NU series tags for terminal blocks, Cabur is proud to present the new NU0835S and NU1035S, the new tags for 1.5 mm2 terminal blocks, to marking clean and fast, compatible with the EFC Cabur and push-in of other manufacturers.

READ MORE »

ISCRIVITI ALLA NEWSLETTER

Name(Required)
Email(Required)
Address(Required)
Privacy(Required)
The consent to the subscription to the Cabur Newsletter can be revoked, at any time, using the unsubscribe procedure available on the emails sent. PRIVACY POLICY

CABUR CUSTOMER CARE

for technical support
+39 019 58999.219  customercare@cabur.it
for commercial support
+39 019 589991 vendite@cabur.it

from monday to friday 8:30-12:30 13:00-17:00